More of the interior walls going up and starting the plumbing

 At this stage we were finishing up the interior wall layout and starting the running of plumbing and installing the tubs and showers. Overall this stage was pretty easy, just following the plans for each wall as indicated. I used a 22LR blank hammer shot to hold the bottom plates to the flooring. The first ones I tried were too strong and drove the nail straight into the concrete. I had to back off to the weakest load to the nails would not shoot through the bottom plate since they are aluminum and it doesn't take much to put the nail through it. 
















This is the false wall, the plywood is where the tankless water heater and the filtration system will go.





Comments

Post a Comment

Popular posts from this blog

It is finally here!

Image
 Our house kit was delivered on 14 December 2020. We really needed to have a forklift to help offload. Once again my neighbor had the forklift attachment for the skidsteer. They offloaded from down by the creek and used the forklift to move it up to the pad area. They laid everything out where we could access it as needed after they were done. They said they would need 4 days to get the posts set, the foundation forms installed, and the roof trusses and porches put in.  As part of the uplift we purchased they did the last step of Phase 1 which is getting the orientation done. We had set the orientation for the house, but they said there would be an issue with the porches on the edge of the pad. They remeasured and set the orientation correctly and set the batter boards which is the start of Phase 2 - Setting Column Anchors. Once again they were very professional and took care of everything and answered all our questions we had about the build process after they would leave. Th...
Read more

Putting the roof on the porches

Image
While the contractors were here we discussed the different phases of the build. They said you move some things around such as the roof. We skipped ahead to Phase 8 putting on the porch roof panels. I put the panels next to the porches to help speed up the process. My brother and sister showed up to help and then my neighbor with the skidsteer (which we needed for additional height to reach the front porch due to the slope of the property). The instructions were very detailed starting on page 69 of my book. Careful attention needs to be done to ensure you get the first panel square and ensuring your extended rib faces inward. The first rib needs to be 1 inch off the end of the truss. After this it was an easy process to continue on each panel until we were done. Since we didn't do stage 7 yet, we could not finish the installation of the corner trim.  This stage did not even require 1/2 day to perform. 
Read more

Background on our journey

Image
I wanted to provide this blog to others that may buy a home from budgethomekits.com. There were many mistakes that I made, some improvements to how they did a few things and a lot of things that they do not even cover in the instructions. In no way is this a complaint to the company as they were very helpful and for the most part the instructions were spot on. So here is my story.   In July 2020 I decided to semi-retire from my job in Kansas and buy some property and move to either Arkansas or Missouri. I was originally planning to build a log cabin kit but stumbled onto the BudgetHomeKits website and liked the selection and pricing of what they had to offer. My wife and I settled on the Magnolia kit and put the deposit on the kit that was in clearance at a greatly reduced price - boy was that a good move as the price of metal started going up and up and our price was locked in.  In late August we found 50 acres in Southeastern Missouri about 120 miles south of St Louis. ...
Read more